ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_853

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_855

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
807

TM 5-3805-261-34 ENGINE MAINTENANCE. (cont) 13-5. Crankshaft Main Bearings. (Sheet 8 of 12) INSTALLATION (Front, Center and Rear Main Bearings and Thrust Bearings) (cont) 4. Tighten three of six bolts (1) at bearing tab side of three bearing caps (3, Figure 13-23) to 30 ft-lb torque. 5. Tighten three of six bolts (1) opposite bearing tab side of three bearing caps (3) to 30 ft-lb torque. 6. Mark six bolts (1) and three bearing caps (3) with chalk. 7. Tighten three of six bolts (1) opposite bearing tab side of three bearing caps (3) a further 90 degrees, using chalk mark as an aid in estimating how far to tighten bolts (1). 8. Tighten three of six bolts (1) at bearing tab side of three bearing caps (3) a further 90 degrees. REMOVAL (Intermediate Main Bearings) 1. Remove four bolts (7), washers (8) and two items 9 and 10 as an assembly (Figure 13-24). 2. Remove lower half of two inter- mediate main bearings (10) from two crankshaft bearing caps (9, Figure 13-25). Figure 13-23. Figure 13-24. Figure 13-25. Go to Sheet 9 13-28

Privacy Statement
Press Release
Contact