TM 5-3805-261-34
HYDRAULIC SYSTEM MAINTENANCE.
10-19.
Hydraulic Side Shift Cylinder. (Sheet 3 of 7)
REMOVAL
NOTE
All hose and tube assemblies
must be tagged before
disconnecting to aid in
installation. Cap all hose
and tube ends to prevent
contamination.
13. Disconnect hose assembly (17,
Figure 10-142).
14. Remove connector (18) and
preformed packing (19). Discard
preformed packing (19).
15. Disconnect hose assembly (20).
16. Remove connector (21) and
preformed packing (22). Discard
preformed packing (22).
17. Remove nut (23), washer (24),
bolt (25), pin (26) and washers
(27 and 28, Figure 10-143).
WARNING
Weight of bracket is 75 lbs.
Use adequate hoist and sling
for lifting. Failure to
follow this procedure may
cause INJURY. If you are
injured, seek medical aid
immediately.
18. Attach hoist and sling to bracket
(36) and position floor jack
under cylinder (38).
19. Remove cotter pin (29), nut (30),
washer (31), nut (32), washers
(33 and 34), nut (35), bracket
(36) and washer (37). Discard
cotter pin (29).
20. Remove hoist and sling from
bracket (36).
Go to Sheet 4
10-111
Figure 10-143.
Figure 10-142.
