FRONT AXLE MAINTENANCE. (cont) - TM-5-3805-261-34

FRONT AXLE MAINTENANCE. (cont) - TM-5-3805-261-34_466

FRONT AXLE MAINTENANCE. (cont) - TM-5-3805-261-34_468

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
420

TM 5-3805-261-34 FRONT AXLE MAINTENANCE. (cont) 5-16. Leaning Wheel Mechanism. (Sheet 6 of 8) INSTALLATION (cont) 10. Install two fittings (31) in arm (32, Figure 5-102) on right, front of vehicle. 11. Using assembled spacer, nut, pulling adapter, washer, nut, puller assembly and pump group, install bearing (30) flush with lower surface of collar on arm (32). 12. Install bearing (29) flush with upper surface of collar on arm (32). 13. Attach hoist and sling to items 32 thru 29 as an assembly (Figure 5-101). 14. Position items 32 thru 29 as an assembly on vehicle. 15. Install pin (28). Groove in pin (28) must aline with opening in arm (32). 16. Remove hoist and sling. 17. Install lock (27), washer (26), bolt (25) and nut (24, Figure 5-100). Tighten nut (24) to 515 ft-lb torque. 18. Install two washers (23 and 22) and bolts (21). 19. Install two fittings (19) in bar (20, Figure 5-99). 20. Using assembled washer, puller assembly, pump group, screw, nut and adapter, install two bearings (18). 21. Install four seals (17) with lips Figure 5-99. toward the outside and even with the outside surface of bar (20). Figure 5-102. Figure 5-101. Figure 5-100. Go to Sheet 7 5-80

Privacy Statement
Press Release
Contact