TM 5-3805-261-34
FRONT AXLE MAINTENANCE.
5-16.
Leaning Wheel Mechanism. (Sheet 5 of 8)
INSTALLATION
1.
Install two fittings (43) on arm
(44, Figure 5-105) on left, front
of vehicle.
To prevent damage, special
tools must be used to install
bearings.
2.
Using assembled spacer, nut,
pulling adapter, washer, nut,
puller assembly and pump group,
install bearing (42) flush with
lower surface of collar on arm
(44).
3.
Install bearing (41). These
tools must also be used to
install flush with upper surface
of collar on arm (44).
4.
Attach hoist and sling to items
44 thru 41 as an assembly (Figure
5-104).
5.
Position items 44 thru 41 as an
assembly on vehicle.
6.
Install pin (40). Groove in pin
(40) must aline with opening in
arm (44).
7.
Remove hoist and sling.
8.
Install lock (39), washer (38),
bolt (37) and nut (36, Figure
5-103). Tighten nut (36) to 515
ft-lb torque.
9.
Install two washers (35 and 34)
and bolts (33).
Go to Sheet 6
5-79
CAUTION
