FRONT AXLE MAINTENANCE. (cont) - TM-5-3805-261-34

FRONT AXLE MAINTENANCE. (cont) - TM-5-3805-261-34_470

FRONT AXLE MAINTENANCE. (cont) - TM-5-3805-261-34_472

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
424

TM 5-3805-261-34 FRONT AXLE MAINTENANCE. (cont) 5-17. Leaning Wheel Cylinder. (Sheet 2 of 5) REMOVAL Wheel lean lock pin must be installed before disconnect- ing any hose assemblies. Failure to follow this procedure may cause INJURY. If you are injured, seek medical aid immediately. 1. Remove two fittings (1, Figure 5-106) from right side of front axle on vehicle. NOTE All hose and tube assemblies must be tagged before disconnecting to aid in installation. Cap all hose and tube ends to prevent contamination. 2. Disconnect hose assembly (2). 3. Remove elbow (3) and preformed packing (4). Discard preformed packing (4). 4. Remove hose assembly (5), elbow (6) and preformed packing (7, Figure 5-107). Discard preformed packing (7). Weight of cylinder is 55 lbs. Use adequate hoist and sling for lifting. Failure to follow this procedure may cause INJURY. If you are injured, seek medical aid immediately. 5. Install hoist and sling on items Figure 5-109. 15 thru 17 as an assembly (Figure 5-109). WARNING WARNING Figure 5-106. Figure 5-107. Go to Sheet 3 5-84

Privacy Statement
Press Release
Contact