TM 5-3805-261-34STARTING SYSTEM MAINTENANCE.4-12.StartingMotor(Bosch). (Sheet 9 of 11)ASSEMBLY14.Install washer (37) on armature(43, Figure 4-76) shaft.15.Using clean grease, lubricate thegroove on drive (35). Usingclean oil, fill space betweendrive (35) housing and drive (35)pinion. Push pinion into housingas far as it will go.16.Position lever (36) in housing(39).17.Install drive (35) on armature(43) shaft and lever (36) ingroove of drive (35).18.Using clean grease, lightlylubricate pin (33).19.Install one of two new preformedpackings (34) and pin (33)through holes in housing (39) andlever (36).20.Install remaining one of two newpreformed packings (34) and ring(32) on pin (33).21.Install new preformed packing(29) on groove in housing (30,Figure 4-75).Figure 4-75.22.Using clean oil, lightly lubri-cate outer diameter of newpreformed packing (29).23.Using clean grease, lubricatecenter of both sides of newspacer (28).24.Install new spacer (28) inhousing (30).25.Using suitable driver and press,install new bearing (27).Go to Sheet 104-73Figure 4-76.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
