TM 5-3805-261-34
STARTING SYSTEM MAINTENANCE. (cont)
4-12.
Starting Motor (Bosch). (Sheet 10 of 11)
ASSEMBLY (cont)
26.
Install items 30 thru 27 as an
assembly on housing (39, Figure
4-74) alining matchmarks.
27.
Install six screws (26) and
tighten to 9 ft-lb torque.
28.
Install new preformed packing
(25) on groove of housing (53,
Figure 4-73).
29.
Using clean oil, lubricate outer
diameter of new preformed packing
(25).
30.
Position plate assembly (24) on
housing (53).
31.
Install four screws (23) and
tighten to 4 ft-lb torque.
32.
Position terminal stud (22) on
plate (24).
33.
Install two screws (21) and four
springs (20).
34.
Using hook, lift springs (20) and
install four brushes (19) in
holders on plate (24).
35.
Position two field coil (51) wire
assemblies and two of four
brushes (19) wire assemblies on
plate (24).
36.
Install two of four screws (18).
37.
Position remaining two of four
brushes (19) wire assemblies on
plate (24).
38.
Install remaining two of four
screws (18).
39.
Install bushing (17) on terminal
stud (22).
Go to Sheet 11
4-74
Figure 4-74.
Figure 4-73.