STARTING SYSTEM MAINTENANCE. (cont)

STARTING SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_347

Section V. MONITORING SYSTEM MAINTENANCE

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
302

TM 5-3805-261-34 STARTING SYSTEM MAINTENANCE. 4-12. Starting Motor (Bosch). (Sheet 11 of 11) ASSEMBLY 40. Using clean grease, lubricate center of both sides of new spacer (15, Figure 4-72). 41. Install new spacer (15) in cover (16). 42. Using suitable driver and press, install new bearing (14). 43. Install new seal (13) and plug (12). 44. Install items 16 thru 12 as an assembly on housing (53, Figure 4-71). 45. Install four lockwashers (11) and nuts (10). Tighten nuts (10) to 4 ft-lb torque. 46. Install new seal (9), bushing (8) and washer (7). 47. Connect wire assembly (6) at terminal. 48. Install lockwasher (5) and nut (4). Tighten nut (4) to 22 ft-lb torque. 49. Install bus bar (3), lockwasher (2) and nut (1). NOTE Return 130G Grader to original equipment condition. Figure 4-71. End of Task 4-75 Figure 4-72.

Privacy Statement
Press Release
Contact