STARTING SYSTEM MAINTENANCE. (cont)

STARTING SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_339

STARTING SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_341

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
294

TM 5-3805-261-34 STARTING SYSTEM MAINTENANCE. 4-12. Starting Motor (Bosch). (Sheet 3 of 11) DISASSEMBLY 9. Remove bushing (17) from terminal stud (22,Figure 4-73). 10. Remove four screws (18). 11. Disconnect four brushes (19) wire assemblies. 12. Disconnect two field coil (51) wire assemblies. 13. Lift four springs (20) with suitable hook to remove four brushes (19). 14. Remove four brushes (19). 15. Remove four springs (20). 16. Remove two screws (21) and terminal stud (22). NOTE The following procedure is Figure 4-73. for the removal of one screw. Repeat steps 19 thru 21 for the removal of the remaining three screws. 17. Install two M5X0.8 hex nuts on screw (23). 18. Using suitable wrench to turn inside nut of two M5X0.8 hex nuts, remove screw (23) from plate assembly (24). 19. Remove two M5X0.8 hex nuts from screw (23). 20. Remove plate assembly (24) from housing (53). 21. Remove and discard preformed packing (25) from housing (53). 4-67

Privacy Statement
Press Release
Contact