STARTING SYSTEM MAINTENANCE. (cont)

STARTING SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_334

STARTING SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_336

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
289

TM 5-3805-261-34 STARTING SYSTEM MAINTENANCE. (cont) 4-11. Starting Motor (Prestolite). (Sheet 7 of 9 ASSEMBLY (cont) 6. Install new seal (46) onto plate (47, Figure 4-66). 7. Install four brushes (45) and springs (44). 8. Install insulation (43) onto plate (47). 9. Install items 47 thru 43 as an assembly into frame (63, Figure 4-65). 10. Install washer (42) and spacer (41). 11. Install two washers (40) and washers (39 and 38) on armature (37). NOTE Coat bearing surfaces of armature with engine oil SAE 10 and lubricate armature shaft splines with MIL-G- 23827A. 12. Install armature (37) into frame (63). 13. Using an arbor press, install bearing (35) into housing (36, Figure 4-64). 14. Install plug (34). 15. Dip wick (33) in engine oil SAE 20 and install in housing (36). 16. Install plug (32). 17. Install washer (31), drive (30) and yoke (29). 18. Install new preformed packing (28) and washer (27). Go to Sheet 8 4-62 Figure 4-66. Figure 4-65. Figure 4-64.

Privacy Statement
Press Release
Contact