TM 5-3805-261-34
STARTING SYSTEM MAINTENANCE. (cont)
4-12.
Starting Motor (Bosch). (Sheet 2 of 11)
DISASSEMBLY
1.
Position starting motor in soft-
jawed vise.
NOTE
Using scriber, matchmark
cover and housings to aid in
assembly.
2.
Remove nut (1), lockwasher (2)
and bus bar (3, Figure 4-71).
3.
Remove nut (4) and lockwasher
(5).
NOTE
All wire, cable and harness
assemblies must be tagged
before disconnecting to aid
in installation.
4.
Disconnect wire assembly (6) at
terminal.
5.
Remove washer (7), bushing (8)
and seal (9). Discard seal (9).
6.
Remove four nuts (10), lock-
washers (11) and items 12 thru 16
as an assembly.
7.
Remove plug (12) and seal (13)
from cover (16, Figure 4-72).
Discard seal (13).
8.
Using spring collet and
extractor, remove and discard
bearing (14) and spacer (15) from
cover (16).
Figure 4-72.
Go to Sheet 3
4-66
Figure 4-71.
