STARTING SYSTEM MAINTENANCE. (cont)

STARTING SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_333

STARTING SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_335

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
288

TM 5-3805-261-34 STARTING SYSTEM MAINTENANCE. 4-11. Starting Motor (Prestolite). (Sheet 6 of 9) CLEANING 2. Remove loose particles from armature (37, Figure 4-70) with compressed air and wipe with a clean cloth dampened with dry cleaning solvent. Clean commutator lightly with sandpaper and remove all traces of dust with low pressure compressed air. 3. Clean all other parts. Refer to Chapter 2. INSPECTION Inspect all parts. Refer to Chapter 2. ASSEMBLY 1. Install stud (62), spacer (61), lockwasher (60) and bolt (59) to inside of frame (63, Figure 4-68). 2. Install spacer (58), stud (57), lockwasher (56), nut (55), connector (54), lockwasher (53) and nut (52) onto bolt (59) on outside of frame (63). 3. Install coil (51) into frame (63, Figure 4-67). 4. Install four studs (50) and screws (49). 5. Install three screws (48). Figure 4-67. Go to Sheet 7 4-61 Figure 4-70. Figure 4-68.

Privacy Statement
Press Release
Contact