TM 5-3805-261-34ENGINE MAINTENANCE.3-10. VibrationDamper.(Sheet 2 of 2)REMOVAL1.Loosen bolt from front of engine (Figure 3-40).Do not remove.WARNINGVibration damper is under extremepressure. Remove carefully. Failure tofollow this procedure may cause INJURY.If you are injured, seek medical aidimmediately.2.Using suitable puller, loosen hub fromcrankshaft.3.Remove bolt, washer and hub.CLEANINGClean all parts. Refer to Chapter 2.INSPECTIONInspect all parts. Refer to Chapter 2.INSTALLATION1.Position hub on crankshaft (Figure 3-40).2.Install washer and bolt. Tighten bolt to 230 ft-lb torque. Tap with hammer. Retighten bolt to230 ft-lb torque.NOTEReturn 130G Grader to original equipmentcondition.End of Task3-59Figure 3-40.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
