TM 5-3805-261-34
ENGINE MAINTENANCE.
3-11. Flywheel and Flywheel Housing. (Sheet 2 of 5)
REMOVAL
1.
Remove plugs (1 and 2, Figure 3-41) from rear
of engine.
2.
Using scriber, matchmark flywheel assembly
(4) and crankshaft at same location.
3.
Install FT120 lifting bracket and 3/8-16-2B
THD bolt on flywheel assembly (4).
WARNING
Weight of flywheel assembly is approximately 120
pounds. Use adequate hoist and sling for lifting.
Failure to follow this procedure may cause
INJURY. If you are injured, seek medical aid
immediately.
4.
Attach hoist and sling to FT120 lifting bracket.
5.
Remove nine bolts (3).
6.
Remove flywheel assembly (4).
7.
Remove hoist and sling and FT120 lifting
bracket.
Go to Sheet 3
3-61
Figure 3-41.
