ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_106

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_108

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
62

TM 5-3805-261-34 ENGINE MAINTENANCE. 3-6. Engine Front Covers. (Sheet 2 of 4) REMOVAL 1. Remove bolt (1), washer (2) and clip (3, Figure 3-15) from front of engine. NOTE All hose and tube assemblies must be tagged before disconnecting to aid in installation. Cap all hose and tube ends to prevent contamination. 2. Disconnect hose assembly (4) from fuel priming pump and move away from front cover (7). 3. Install spacer (9) to each side of engine between oil pan plate and the engine block. 4. Remove two bolts (5), washers (6) and cover (7, Figure 3-16). 5. Remove and discard preformed pack- in (8) from front cover (7). NOTE Mark all bolts to ensure that during installation the bolts are installed in their original place. 6. Remove six nuts (10) and washers (11, Figure 3-17). 7. Remove cover (12) and gasket (13). Discard gasket (13). Remove all gasket material from mounting sur- faces. 8. Remove two bolts (14). 9. Remove bolts (15), nuts (16) and washers (17). 10. Remove cover (18) and gasket (19). Discard gasket (19). Remove all gasket material from mounting sur- faces. Go to Sheet 3 Figure 3-15. Figure 3-16. Figure 3-17. 3-35

Privacy Statement
Press Release
Contact