TM 5-3805-261-20
BODY, CAB, HOOD AND HULL MAINTENANCE. (cont)
13-10.
Cab Doors and Latch Assemblies. (Sheet 2 of 9)
REMOVAL
WARNING
Weight of each door assembly is
approximately 85 lbs. Use adequate
hoist and sling for lifting. Failure to
follow this procedure may cause
INJURY. If you are injured, seek
medical aid immediately.
1.
Disconnect cab switch panel. Refer to
paragraph 7-43, steps 1 and 5.
2.
Attach hoist and sling to items 21 thru 64 as
an assembly in right door (Figure 13-31).
NOTE
Use pencil and outline door hinge to
aid in installation.
3.
Remove three nuts (1), washers (2), plate
(3) and three spacers (4).
4.
Remove two nuts (5), washers (6), plate (7)
and two spacers (8).
5.
Remove two screws (9), nuts (10) and
washers (11, Figure 13-32).
6.
Remove three screws (12), nuts (13) and
washers (14).
7.
Remove nine screws (15), nuts (16) and
washers (17).
8.
Using hoist and sling, remove items 21 thru
64 as an assembly.
9.
Remove hoist and sling.
10.
Attach hoist and sling to items 21 thru 64 as
an assembly in left door (Figure 13-33).
Go to Sheet 3
13-36
Figure 13-31.
Figure 13-32.
Figure 13-33.
