TM 5-3805-261-20
BODY, CAB, HOOD AND HULL MAINTENANCE. (cont.)
13-9.
Cab Window Panels. (Sheet 2 of 4)
REMOVAL
WARNING
When working with glass, always
wear safety goggles and protective
gloves. Failure to do so may cause
INJURY. If injured, seek medical aid
immediately.
NOTE
The
following
is
a
maintenance
procedure for the rear window glass.
The maintenance procedure for the
upper front windshield glass, right
and left side window glass, right and
left upper door window glass and
right and left lower door window
glass is identical.
1.
Using a seal installer tool, unlock seal (2,
Figure 13-29) in rear window, outside of
cab. Place curved end of seal installer tool
in between locking lips at butted ends of
seal (2). Work seal installer tool around the
circumference of the window pulling locking
lip away from cab.
NOTE
Step 2 requires two mechanics.
2.
Remove glass (1). Two mechanics must tilt
top of glass (1) away from cab and remove
from bottom channel.
3.
Remove seal (2) and discard if necessary.
Pull out seal (2) from edge of window
opening.
Figure 13-29.
Go to Sheet 3
13-32