TM 5-3805-261-20
BODY, CAB, HOOD AND HULL MAINTENANCE.
13-9.
Cab Window Panels. (Sheet 3 of 4)
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
1.
Inspect
seal
(2).
Replace
if
torn,
deteriorated or otherwise damaged.
2.
Inspect all other parts. Refer to Chapter 2.
INSTALLATION
1.
Install seal (2). Start one end of seal (2) on
side of window opening, with locking lip
towards the outside of cab.
2.
Push seal (2) onto edge of window opening
around the circumference of opening until
ends are closed together smooth and tight.
If installing new seal (2, Figure 13-30), cut
bulk seal material 1/8 inch per foot of
window opening circumference past the
starting point, then close ends.
NOTE
Step 3 requires two mechanics.
3.
Two mechanics must position bottom of
glass (1) into channel of seal (2) as far as
possible. Do not use too much force.
Figure 13-30.
Go to Sheet 4
13-33
