TM 5-3805-261-20
BODY, CAB, HOOD AND HULL MAINTENANCE. (cont)
13-9.
Cab Window Panels. (Sheet 4 of 4)
INSTALLATION (cont)
4.
Install glass (1). Use seal installer tool to lift
edge of seal (2) around the circumference
of the window, so glass (1, Figure 13-30)
can slip into position.
5.
Inspect seal (2) in rear window, inside of
cab. Make sure edge of seal (2) is over
glass (1).
6.
Lock seal (2) in rear window, outside of cab.
Apply mild soap and water solution to
locking lip around circumference of seal (2).
7.
With seal installer tool, insert curved end
between locking lip and groove at any point
away from the butted ends. Work seal
installer tool along groove until locking lip is
locked into position around circumference of
the window.
NOTE
Return
130G
Grader
to
original
equipment condition.
Figure 13-30.
End of Task
13-34