INSTALLATION - TM-5-3805-261-20

TM-5-3805-261-20 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
309

TM 5-3805-261-20 STARTING MOTOR MAINTENANCE. (cont) 7-13. Solenoid (Prestolite). (Sheet 3 of 4) CLEANING Clean all parts. Refer to Chapter 2. INSPECTION Inspect all parts. Refer to Chapter 2. INSTALLATION 1. Position and install solenoid (13) shaft into starting motor (14, Figure 7-23) lever housing. 2. Install four washers (12), lockwashers (11) and screws (10). 3. Using fabricated adapter tool, install new lock nut (9). Do not tighten lock nut (9). 4. Install screw (6, Figure 7-22). 5. Position wire assembly (5) and install screw (4). 6. Install connector (3), two lockwashers (2) and nuts (1). Tighten two nuts (1) to 22 ft-lb torque. ADJUSTMENT 1. Measure pinion clearance on starting motor (14). Connect starting motor (14, Figure 7- 24) to 12-volt battery. Momentarily touch jumper wire "A" to shift drive pinion into cranking position. Figure 7-23. Figure 7-22. Figure 7-24. Go to Sheet 4 7-46

Privacy Statement
Press Release
Contact