TM 5-3805-261-20
STARTING MOTOR MAINTENANCE.
7-12.
Solenoid (Delco-Remy). (Sheet 3 of 3)
INSTALLATION
1.
Position solenoid (8). Slide plunger into
solenoid (8) and aline mounting holes on
starting motor (9, Figure 7-21).
2.
Install four screws (7).
3.
Install connector (6), two lockwashers (5)
and nuts (4) Tighten two nuts (4) to 22 ft-lb
torque.
4.
Position wire assembly (3) on G terminal
stud of solenoid (8).
5.
Install lockwasher (2) and nut (1).
NOTE
Return
130G
Grader
to
original
equipment condition.
End of Task
7-43
