TM 5-3805-261-20 STARTING MOTOR MAINTENANCE.  (cont) 7-13. Solenoid (Prestolite).  (Sheet 1 of 4) This task covers: a. Removal b. Cleaning c. Inspection d. Installation e. Adjustment f. Testing INITIAL SETUP: Applicable Configurations Personnel Required All Construction equipment repairer MOS 62B Tools General Mechanic’s Tool Kit: References Automotive (NSN 5180-00-177-7033) TM 5-3805-261-10 Two 12-volt batteries Three jumper wires Special Environmental Conditions Adapter tool, Appendix D None Interference block, Appendix D General Safety Instructions None Test Equipment 12-volt test lamp Torques Switch Except for special torques shown, all fasteners are tightened to Materials/Parts standard torques.  Refer to Small tags, Item 41, Appendix E. Appendix C Dry cleaning solvent, Item 14, Appendix C Clean cloths, Item 39, Appendix C Preformed packing, Item 8 Lock nut, Item 9 Troubleshooting References None Equipment Condition TM 5-3805-261-10 Vehicle parked on level ground. Parking/emergency brake applied. Equipment lowered to the ground. Engine stopped. Master disconnect switch off. Paragraph 13-5 Right side panel assembly removed. Paragraph 7-11 Starting motor removed (if necessary). Paragraph 7-112 Disconnect positive cable on right side. Go to Sheet 2 Change 1  7-44