TM 5-3805-261-20
STARTING MOTOR MAINTENANCE. (cont)
7-14.
Solenoid (Bosch). (Sheet 3 of 3)
INSTALLATION
1.
Install new seal (15), solenoid (14), four
washers (13) and screws (12) on starting
motor (16, Figure 7-30). Make sure
solenoid (14) input shaft engages with
internal starting motor (16) lever.
2.
Install connector (10), lockwasher (9) and
nut (8) on starting motor terminal (11).
3.
Install lockwasher (6) and nut (5) on
solenoid terminal (7, Figure 7-29). Tighten
nut (5) to 22 ft-lb torque.
4.
Position wire assembly (3) on solenoid
terminal (4).
5.
Install lockwasher (2) and nut (1).
NOTE
Return
130G
Grader
to
original
equipment condition.
Figure 7-30.
Figure 7-29.
End of Task
7-50
