TM 5-3805-261-20
STARTING MOTOR MAINTENANCE.
7-14.
Solenoid (Bosch). (Sheet 2 of 3)
NOTE
REMOVAL
Use
Bosch
Solenoids
only
with
Bosch Starters.
1.
Remove nut (1) and lockwasher (2, Figure
7-29).
NOTE
All
wire,
cable
and
harness
assemblies must be tagged before
disconnecting to aid in installation.
2.
Disconnect wire assembly (3) from solenoid
terminal (4) on starting motor (16).
3.
Remove nut (5) and lockwasher (6) from
solenoid terminal (7).
4.
Remove
nut
(8),
lockwasher
(9)
and
connector (10) from starting motor terminal
(11, Figure 7-30).
5.
Remove four screws (12), washers (13),
solenoid (14) and seal (15) from starting
motor (16). Raise solenoid (14) slightly
before removing. Discard seal (15).
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
Figure 7-29.
Figure 7-30.
Go to Sheet 3
7-49
