TM 5-3805-261-20
STARTING MOTOR MAINTENANCE. (cont)
7-11.
Starting Motor. (Sheet 2 of 4)
REMOVAL
1.
Remove nut (1) and lockwasher (2) from
terminal stud (8, Figure 7-18) on left side of
engine.
NOTE
All
wire,
cable
and
harness
assemblies must be tagged before
disconnecting to aid in installation.
2.
Disconnect
wire
assembly
(3)
cable
assembly (6), and wire assembly (7).
3.
Remove lockwasher (4).
4.
Disconnect cable assembly (5).
5.
Remove nut (9) and lockwasher (10) from
terminal stud (12).
6.
Disconnect wire assembly (11).
7.
Remove nut (13) and lockwasher (14) from
terminal stud (18, Figure 7-19).
8.
Disconnect wire assemblies (15, 16 and
17).
9.
Remove three bolts (19), washers (20) and
clip (21) from starting motor drive housing.
Go to Sheet 3
Figure 7-19.
Figure 7-18.
7-38
