TM 5-3805-261-20
HYDRAULIC SYSTEM MAINTENANCE.
15-32.
Hydraulic Oil Cooler. (Sheet 2 of 4)
REMOVAL
1.
Remove two plugs (1) to drain core
assembly (12, Figure 15-155). Bold
suitable container under two plugs (1).
2.
Install
two
plugs
(1)
to
prevent
contamination.
NOTE
All hose and tube assemblies must
be tagged before disconnecting to
aid in installation. Cap all hose and
tube ends and plug all open oil ports
to prevent contamination.
3.
Disconnect two hose assemblies (2).
4.
Remove two connectors (3) and preformed
packings (4). Discard two preformed
packings (4).
5.
Remove two nuts (5), washers (6) and
brackets (7).
NOTE
Remove two bolts only if inspection
indicates replacement is necessary.
If bolts must be removed, it will first
be necessary to remove radiator
support. Refer to paragraph 6-36.
6.
Remove two bolts (8) and washers (9,
Figure 15-156) through cut-outs for vehicle
rear signal lights in radiator grille. Discard
two bolts (8), if necessary.
Figure 15-155.
Figure 15-156.
Go to Sheet 3
15-177
