TM 5-3805-261-20 HYDRAULIC SYSTEM MAINTENANCE. (cont) 15-32. Hydraulic Oil Cooler. (Sheet 1 of 4) This task covers: a. Removal b. Cleaning c. Inspection d. Installation INITIAL SETUP Applicable Configurations Personnel Required All Construction equipment repairer MOS 62B Tools General Mechanic’s Tool Kit: References Automotive (NSN 5180-00-177- TM 5-3805-261-10 7033) LO 5-3805-261-12 Suitable container Special Environmental Conditions Test Equipment None None General Safety Instructions Materials/Parts None Dry cleaning solvent, Item 14, Appendix C Torques Clean cloths, Item 39, All fasteners are tightened to Appendix C standard torques.  Refer to Detergent, Item 8, Appendix C Appendix E. Small tags, Item 41, Appendix C Two preformed packings, Item 4 Seal (Bulk material), Item 13 Two bolts, Item 8 Caps Plugs Troubleshooting References None Equipment Condition TM 5-3805-261-10 Vehicle parked on level ground. Parking/emergency brake applied. Equipment lowered to the ground. Engine stopped. Master disconnect switch off. Hydraulic pressure relieved. Paragraph 6-35 Shields, baffles and plates removed. Paragraph 6-46 Fan removed. Paragraph 7-82 Vehicle rear signal lights removed. Go to Sheet 2 15-176