TM 5-3805-261-20
HYDRAULIC SYSTEM MAINTENANCE. (cont)
15-25.
Blade Tip Lines, Fittings and Hoses. (Sheet 6 of 10)
REMOVAL (cont)
22.
Remove hose assembly (47, Figure 15-105)
from rear, right side of drawbar.
23.
Remove hose assembly (48) from blade tip
cylinder.
24.
Remove elbow (49) and preformed packing
(50). Discard preformed packing (50).
25.
Remove connector (51) and preformed
packing (52). Discard preformed packing
(52).
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
INSTALLATION
1.
Install new preformed packing (52) and
connector (51, Figure 15-105) to blade tip
cylinder in rear, right side of drawbar.
2.
Install new preformed packing (50) and
elbow (49) in blade tip cylinder.
3.
Install hose assembly (48).
4.
Install hose assembly (47).
5.
Install two clamps (46) and bolts (45, Figure
15-104) in rear of drawbar.
Figure 15-105.
Go to Sheet 7
15-131
