TM 5-3805-261-20
HYDRAULIC SYSTEM MAINTENANCE.
15-25.
Blade Tip Lines, Fittings and Hoses. (Sheet 10 of 10)
INSTALLATION
24.
Install two new preformed packings (2) and
elbows (1, Figure 15-94) to control valve
group (second assembly from outside)
under front, left side of cab.
25.
Connect two hose assemblies (23, Figure
15-93).
WARNING
Only
a
qualified
operator
may
perform the next procedure. All other
personnel must clear the immediate
area. Failure to follow this procedure
may cause INJURY. If you are
injured,
seek
medical
aid
immediately.
26.
Start engine. Refer to TM 5-3805-261-10.
27.
Operate blade tip control. Move system
through at least five full movements of
travel to bleed air from the system.
28.
Stop engine.
29.
Inspect hose assemblies and connections
for leaks.
30.
Refill hydraulic tank to proper level. Refer
to LO 5-3805-261-12.
NOTE
Return
130G
Grader
to
original
equipment condition.
Figure 15-94.
Figure 15-93.
End of Task
15-135
