14
TM 5-3805-293-23-5
FIELD MAINTENANCE
-
CIRCLE DRIVE SWIVEL REPAIR
0
322
Removal, Disassembly, Cleaning and Inspection, Assembly, Installation
INITIAL SETUP
References
Tools and Special Tools
0
0
Tool Kit, General Mechanic's
0
(WP 0354, Item 83)
0
Equipment Condition
0
Materials/Parts
Machine parked (TM 5-3805-293-10)
0
0
Cap Set, Protective, Dust and Moisture
Articulation lock pin installed
(WP 0355, Item 7)
(TM 5-3805-293-10)
0
0
Rag, Wiping (WP 0355, Item 25)
Vacuum cap installed (WP 0221)
0
0
Tag, Marker (WP 0355, Item 35)
0
Drawings Required
0
Cotter pin
0
TM 5-3805-293-24P, Figure 109, 164
O-ring (20)
0
0
Seal (11)
Estimated Time to Complete
0
0
Shim
3.5 Hr
0
0
Personnel Required
0
Two
0
REMOVAL
000322
WARN I N G
Personal injury can result from hydraulic oil pressure and hot oil.
Hydraulic oil pressure can remain in hydraulic system after engine has been stopped.
Serious injury can be caused if this pressure is not released before any service is done on
hydraulic system.
Make sure all work tools have been lowered to the ground and oil is cool before removing
any components or lines. Remove oil filler cap only when engine is stopped and filler cap
is cool enough to touch with your bare hand.
Failure to follow these warnings ma result in injury to personnel.
y
N OT E
Care must be taken to ensure that fluids are contained during inspection, maintenance,
testing, adjusting and repair of machine. Be prepared to collect fluid with suitable
containers before opening any compartment or disassembling any component containing
fluids.
Cap all open lines and fittings to prevent dirtfrom entering system and to prevent leakage.
Keep all parts clean from contaminants. Contaminants may cause rapid wear and
shortened component life.
Tag and mark lines to aid in installation.
0322-1