TM 5-3805-293-23-4
0245
REMOVAL
000245
N OT E
Tag hoses to aid in installation.
1. Install wheel lean lock bolt (Figure 1, Item 3) and nut (Figure 1, Item 1) on front axle (Figure 1, Item 2). Hand
tighten only.
Figure 1. Wheel Lean Lock Bolt.
0245
2. Remove all-wheel drive (AWD) manifold (WP 0248).
WARN I N G
Personal injury can result from hydraulic oil pressure and hot oil.
Hydraulic oil pressue can remain in the hydraulic system after the engine has been
r
stopped. Serious injury can be caused if this pressure is not released before any service is
done on the hydraulic system.
Make sure all of the attachments have been lowered and oil is cool before removing any
components or lines. Remove the oil filler cap only when the engine is stopped and the
filler cap is cool enough to touch with your bare hand.
Failure to follow these warnings may result in injury or death to personnel.
N OT E
If performing task on machine with serial number prefix CBS, perform steps 3 and 4. If
performing task on machine with serial number prefix RMY, perform steps 5 and 6.
Change 1