TM 5-3805-293-23-3
0122
REMOVAL
000122
N OT E
If installed, remove ether cylinder (TM 5-3805-293-10).
1. Remove bolt (Figure 1, Item 9), washer (Figure 1, Item 8), clip (Figure 1, Item 7) and ether injection tube
(Figure 1, Item 4) from hydraulic service pack (Figure 1, Item 15).
2. Remove ether injection tube (Figure 1, Item 4) from ether starting valve (Figure 1, Item 3).
N OT E
If equipped with arctic heater, remove clamp and spacer.
3. Remove bolt (Figure 1, Item 5), washer (Figure 1, Item 6), clamp (Figure 1, Item 14), spacer (Figure 1, Item 10)
and clip (Figure 1, Item 12) from hydraulic service pack (Figure 1, Item 15).
4. Disconnect solenoid valve harness connector (Figure 1, Item 13) from fuel pump harness (Figure 1, Item 11)
and remove clip (Figure 1, Item 12) from solenoid valve harness connector (Figure 1, Item 13).
5. Remove two bolts (Figure 1, Item 2), washers (Figure 1, Item 1), and ether starting valve (Figure 1, Item 3)
from hydraulic service pack (Figure 1, Item 15).
Figure 1. Ether Starting Valve.
00122
END OF TASK