TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-08 Machine Articula-
2252-04 Was Active for the
tion Angle Sensor #2 Abnor-
Transmission ECM and the
mal Frequency, Pulse Width
Implement 1 ECM - Replace
or Period - Continued
transmission ECM (WP 0137) and
implement 1 ECM (WP 0268).
Connect secondary steering harness
connector AT-C4 (WP 0009, Figure
122) to articulation angle position
sensor 2 (right) (WP 0009, Figure
123) (WP 0257).
Connect rear chassis harness
connector FA-C5 (WP 0009, Figure
111) to secondary steering wiring
harness AT-C1 (WP 0009, Figure 110)
(WP 0186).
Proceed to step 9.
9. Using MSD (WP 0006), select
2252-08 Code Active - Repeat
Implement 120M and verify 2252- troubleshooting from the beginning of
08 is active.
this diagnostic code.
2252-08 Code Not Active -
Troubleshooting complete.
2252-13 Machine Articula-
System Response:
tion Angle Sensor #2 Out of
ECM will log a diagnostic code.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Verify if Code 2252-13
is Active.
1. Connect MSD (WP 0006). Select
2252-13 Code Active - Proceed to
Implement 120M and verify 2252-
Test Step 2.
13 is active for the transmission
2252-13 Code Not Active -
ECM or the Implement 1 ECM.
Troubleshooting complete.
0031-150
