TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-03 Machine Articula-
10. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
tion Angle Sensor #2 Volt-
continuity between secondary
Replace rear chassis wiring harness
age Above Normal -
steering wiring harness AT-C1
(WP 0188).
Continued
(WP 0009, Figure 110) terminal 8
Remove jumper wire between AT-C4
and terminal 9.
(WP 0009, Figure 122) terminal A and
Resistance should be less than
terminal B.
5.0 Ohms.
Connect secondary steering harness
connector AT-C4 (WP 0009, Figure
122) to articulation angle position
sensor 2 (right) (WP 0009, Figure
123) (WP 0257).
Proceed to step 11.
Resistance More Than 5.0 Ohms -
Replace secondary steering wiring
harness (WP 0186).
Connect rear chassis harness
connector FA-C20 (WP 0009, Figure
113) to transmission ECM J1 (WP
0009, Figure 112) (WP 0137).
Proceed to step 11.
11. Using MSD (WP 0006). Select
2252-03 Code Active - Repeat
Implement 120M and verify 2252- troubleshooting from the beginning of
03 is active.
this diagnostic code.
2252-03 Code Not Active -
Troubleshooting complete.
Test Step 3. Check Articulation
Angle Position Sensor 2 (Right).
1. Using MSD (WP 0006), verify
2252-03 Code Active - Proceed to
2252-03 is active.
Test Step 4.
2252-03 Code Not Active - Replace
articulation angle position sensor 2
(right) (WP 0257).
Proceed to step 2.
2. Using MSD (WP 0006), select
2252-03 Code Active - Repeat
Implement 120M and verify 2252- troubleshooting from the beginning of
03 is active.
this diagnostic code.
2252-03 Code Not Active -
Troubleshooting complete.
0031-133
