TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-02 Machine Articula-
2252-04 Was Active for the
tion Angle Sensor #2 Data
Implement 1 ECM Only - Replace
Erratic, Intermittent or Incor-
implement 1 ECM (WP 0268).
rect - Continued
Connect secondary steering harness
connector AT-C4 (WP 0009, Figure
122) to articulation angle position
sensor 2 (right) (WP 0009, Figure
123) (WP 0257).
Connect rear chassis harness
connector FA-C5 (WP 0009, Figure
111) to secondary steering wiring
harness AT-C1 (WP 0009, Figure 110)
(WP 0186).
Connect rear chassis harness
connector FA-C20 (WP 0009, Figure
113) to transmission ECM J1 (WP
0009, Figure 112) (WP 0137).
Connect rear chassis harness
connector FA-C21 (WP 0009, Figure
124) to transmission ECM J2 (WP
0009, Figure 112).
Proceed to step 5.
2252-04 Was Active for the
Transmission ECM and the
Implement 1 ECM - Replace
transmission ECM (WP 0137) and
implement 1 ECM (WP 0268).
Connect secondary steering harness
connector AT-C4 (WP 0009, Figure
122) to articulation angle position
sensor 2 (right) (WP 0009, Figure
123) (WP 0257).
Connect rear chassis harness
connector FA-C5 (WP 0009, Figure
111) to secondary steering wiring
harness AT-C1 (WP 0009, Figure 110)
(WP 0186).
Proceed to step 5.
5. Using MSD (WP 0006). Select
2252-02 Code Active - Repeat
Trans/Chassis 120M and verify
troubleshooting from the beginning of
2252-02 is active.
this diagnostic code.
2252-02 Code Not Active -
Troubleshooting complete.
0031-129
