TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-02 Machine Articula-
2.
Install a jumper wire between har-
tion Angle Sensor #2 Data
ness connector AT-C4 (WP 0009,
Erratic, Intermittent or Incor-
Figure 122) terminal C and
rect - Continued
machine ground.
Resistance 5.0 Ohms or Less -
Proceed to step 4.
wiring harness connector P-C39
(WP 0009, Figure 70) terminal 17
Proceed to Test Step 8.
and machine ground.
5.0 Ohms.
4. Using MSD (WP 0006) verify
2252-04 Was Active for the
2252-02 was active for the
Transmission ECM Only - Replace
Transmission ECM or the
transmission ECM (WP 0137).
Implement 1 ECM.
Connect secondary steering harness
connector AT-C4 (WP 0009, Figure
122) to articulation angle position
sensor 2 (right) (WP 0009, Figure
123) (WP 0257).
Connect cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to Implement 1 ECM J2 (WP
0009, Figure 71) (WP 0268).
Connect rear chassis harness
connector FA-C5 (WP 0009, Figure
111) to secondary steering wiring
harness AT-C1 (WP 0009, Figure 110)
(WP 0186).
Proceed to step 5.
0031-128