TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-03 Machine Articula-
2. Using digital multimeter, test for
Continuity - Replace rear chassis
tion Angle Sensor #2 Volt-
continuity between rear chassis
wiring harness (WP 0188).
age Above Normal -
harness connector FA-C22 (WP
Connect secondary steering harness
Continued
0009, Figure 47) terminal 40 and
connector AT-C4 (WP 0009, Figure
all other FA-C22 terminals.
122) to articulation angle position
sensor 2 (right) (WP 0009, Figure
There should be no continuity.
123) (WP 0257).
Connect cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to Implement 1 ECM J2 (WP
0009, Figure 71) (WP 0268).
Proceed to step 3.
No Continuity - Replace cab lower
wiring harness (WP 0266).
Connect secondary steering harness
connector AT-C4 (WP 0009, Figure
122) to articulation angle position
sensor 2 (right) (WP 0009, Figure
123) (WP 0257).
Connect rear chassis harness
connector FA-C5 (WP 0009, Figure
111) to secondary steering wiring
harness AT-C1 (WP 0009, Figure 110)
(WP 0186).
Connect rear chassis harness
connector FA-C20 (WP 0009, Figure
113) to transmission ECM J1 (WP
0009, Figure 112) (WP 0137).
Connect rear chassis harness
connector FA-C21 (WP 0009, Figure
124) to transmission ECM J2 (WP
0009, Figure 112).
Proceed to step 3.
3. Using MSD (WP 0006), select
2252-03 Code Active - Repeat
Implement 120M and verify 2252- troubleshooting from the beginning of
03 is active.
this diagnostic code.
2252-03 Code Not Active -
Troubleshooting complete.
0031-138
