TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-03 Machine Articula-
Voltage Between 7.5 and 8.5 Volts -
tion Angle Sensor #2 Volt-
voltage between harness
Proceed to Test Step 3.
age Above Normal -
connector AT-C4 (WP 0009,
Voltage Less Than 7.5 Volts -
Continued
Figure 122) terminal A and
Proceed to step 5.
terminal B.
Voltage should be 7.5 to 8.5 volts.
5. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
6. Disconnect rear chassis harness
connector FA-C20 (WP 0009,
Figure 113) from transmission
ECM J1 (WP 0009, Figure 112)
(WP 0137).
7. Connect jumper wire between AT-
C4 (WP 0009, Figure 122)
terminal A and terminal B.
Resistance 5.0 Ohms or Less -
Replace transmission ECM (WP
harness connector FA-C20 (WP
0137).
0009, Figure 113) terminal 44 and
Remove jumper wire between AT-C4
terminal 45.
(WP 0009, Figure 122) terminal A and
terminal B.
5.0 Ohms.
Connect secondary steering harness
connector AT-C4 (WP 0009, Figure
122) to articulation angle position
sensor 2 (right) (WP 0009, Figure
123) (WP 0257).
Proceed to step 11.
Proceed to step 9.
9. Disconnect rear chassis harness
connector FA-C5 (WP 0009, Fig-
ure 111) from secondary steering
wiring harness AT-C1 (WP 0009,
Figure 110) (WP 0186).
0031-132