TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-02 Machine Articula-
Test Step 8. Check for Open Rear
tion Angle Sensor #2 Data
Chassis Wiring Harness.
Erratic, Intermittent or Incor- 1. Disconnect rear chassis harness
rect - Continued
connector FA-C22 (WP 0009,
Figure 47) from cab lower wiring
harness P-C69 (WP 0009, Figure
46) (WP 0188).
2. Using digital multimeter, test for
Continuity - Replace cab lower wiring
continuity between rear chassis
harness (WP 0266).
harness connector FA-C22 (WP
Remove jumper wire between AT-C4
0009, Figure 47) terminal 40 and
(WP 0009, Figure 122) terminal C and
machine ground.
machine ground.
There should be no continuity.
Connect secondary steering harness
connector AT-C4 (WP 0009, Figure
122) to articulation angle position
sensor 2 (right) (WP 0009, Figure
123) (WP 0257).
Connect rear chassis harness
connector FA-C20 (WP 0009, Figure
113) to transmission ECM J1 (WP
0009, Figure 112) (WP 0137).
Connect rear chassis harness
connector FA-C21 (WP 0009, Figure
124) to transmission ECM J2 (WP
0009, Figure 112).
Proceed to step 3.
No Continuity - Replace rear chassis
wiring harness (WP 0188).
Remove jumper wire between AT-C4
(WP 0009, Figure 122) terminal C and
machine ground.
Connect secondary steering harness
connector AT-C4 (WP 0009, Figure
122) to articulation angle position
sensor 2 (right) (WP 0009, Figure
123) (WP 0257).
Connect cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to Implement 1 ECM J2 (WP
0009, Figure 71) (WP 0268).
Proceed to step 3.
0031-130