TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-02 Machine Articula-
3. Using MSD (WP 0006). Select
2252-02 Code Active - Repeat
tion Angle Sensor #2 Data
Trans/Chassis 120M and verify
troubleshooting from the beginning of
Erratic, Intermittent or Incor-
2252-02 is active.
this diagnostic code.
rect - Continued
2252-02 Code Not Active -
Troubleshooting complete.
2252-03 Machine Articula-
System Response:
tion Angle Sensor #2 Volt-
ECM will log a diagnostic code.
age Above Normal
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Verify if Code 2252-03
is Active.
1. Connect MSD (WP 0006), select
0041-03 or 0041-04 Code Active -
Trans/chassis 120M and verify
Diagnose 0041-03 or 0041-04 (WP
0041-03 or 0041-04 are active.
0026) for the Implement ECM first.
0041-03 or 0041-04 Code Not Active
- Proceed to step 2.
2252-03 Code Active - Proceed to
2. Using MSD (WP 0006), verify
Test Step 2.
2252-03 is active for the transmis-
sion ECM or the Implement 1
2252-03 Code Not Active -
ECM.
Troubleshooting complete.
Test Step 2. Check 8 Volt Supply
Circuit.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect secondary steering
harness connector AT-C4 (WP
0009, Figure 122) from articula-
tion angle position sensor 2 (right)
(WP 0009, Figure 123) (WP
0257).
3. Turn battery disconnect switch
and ignition switch to the ON
position (TM 5-3805-293-10).
0031-131
