TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-02 Machine Articula-
2.
Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
tion Angle Sensor #2 Data
continuity between secondary
Replace rear chassis wiring harness
Erratic, Intermittent or Incor-
steering wiring harness AT-C1
(WP 0188).
rect - Continued
(WP 0009, Figure 110) terminal 9
Remove jumper wire between AT-C4
and terminal 10.
(WP 0009, Figure 122) terminal B and
Resistance should be less than
terminal C.
5.0 Ohms.
Connect secondary steering harness
connector AT-C4 (WP 0009, Figure
122) to articulation angle position
sensor 2 (right) (WP 0009, Figure
123) (WP 0257).
Connect cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to Implement 1 ECM J2 (WP
0009, Figure 71) (WP 0268).
Proceed to step 3.
Resistance More Than 5.0 Ohms -
Replace secondary steering wiring
harness (WP 0186).
Connect rear chassis harness
connector FA-C20 (WP 0009, Figure
113) to transmission ECM J1 (WP
0009, Figure 112) (WP 0137).
Connect cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to Implement 1 ECM J2 (WP
0009, Figure 71) (WP 0268).
Connect rear chassis harness
connector FA-C21 (WP 0009, Figure
124) to transmission ECM J2 (WP
0009, Figure 112).
Proceed to step 3.
3. Using MSD (WP 0006). Select
2252-02 Code Active - Repeat
Implement 120M and verify 2252- troubleshooting from the beginning of
02 is active.
this diagnostic code.
2252-02 Code Not Active -
Troubleshooting complete.
Test Step 7. Check for Open Cab
Lower Wiring Harness.
1. Remove jumper wire from har-
ness connector AT-C4 (WP 0009,
Figure 122) terminal B and termi-
nal C.
0031-127
