TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2210-08 Auxiliary Lever #7
2. Using MSD (WP 0006), select
2210-03 Code Becomes Active -
Position Sensor Abnormal
Implement 120M and check for
Proceed to step 3.
Frequency, Pulsewidth, or
Active code 2210-03.
2210-03 Not Active - Replace
Period - Continued
transmission ECM (WP 0268).
Proceed to step 5.
3. Install a jumper wire between har-
ness connector P-C33 (WP 0009,
Figure 209) terminal 2 and termi-
nal 3.
4. Using MSD (WP 0006), select
2210-04 Code Becomes Active -
Implement 120M and check for
Replace scarifier lever (WP 0275).
Active code 2210-04.
Proceed to step 5.
2210-04 Not Active - Replace
transmission ECM (WP 0268).
Remove jumper wire from harness
connector P-C33 (WP 0009, Figure
209) terminal 2 and terminal 3.
Connect cab lower harness connector
P-C33 (WP 0009, Figure 209) to
scarifier lever (WP 0009, Figure 210)
(WP 0275).
Proceed to step 5.
5. Using the MSD (WP 0006), select 2210-08 Code Active - Repeat
Implement 120M and verify 2210- troubleshooting code from the
08 is not active.
beginning.
2210-08 Code Not Active -
Troubleshooting complete.
2211-03 Auxiliary Valve #1
System Response:
Port A Solenoid Voltage
ECM will log a diagnostic code.
Above Normal
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
0031-105
