TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2202-14 Steering Valve Con-
8. Remove jumper wire from har-
trol Module Bad Device or
ness connector U-C34 (WP 0009,
Component - Continued
Figure 217) terminal 1, and termi-
nal 6.
Continuity - Replace front
continuity between harness con-
attachment wiring harness (WP
nector U-C1 (WP 0009, Figure
0183).
121) terminal 25 and all other ter-
Proceed to step 11.
minals on harness connector U-
C1 and to machine ground.
There should be no continuity.
Continuity - Replace front
continuity between harness con-
attachment wiring harness (WP
nector U-C1 (WP 0009, Figure
0183).
121) terminal 60 and all other ter-
Proceed to step 11.
minals on harness connector U-
C1 and to machine ground.
4.
There should be no continuity.
11. Using the MSD (WP 0006), select 2202-14 Code Active - Repeat
Implement 120M and verify 2202- troubleshooting code from the
14 is not active.
beginning.
2202-14 Code Not Active -
Troubleshooting complete.
Test Step 4. Test Steering Valve
Control Module Error Signal And
Steering Valve Signal In Front
Attachment Wiring Harness.
1. Install a jumper wire between har-
ness connector U-C34 (WP 0009,
Figure 217) terminal 2, and termi-
nal 4.
Resistance 5.0 Ohms or Less -
continuity between harness con-
Proceed to step 3.
nector U-C1 (WP 0009, Figure
121) terminal 55 and terminal 62.
Replace front attachment wiring
harness (WP 0183).
5.0 Ohms.
Proceed to step 6.
3. Remove jumper wire from har-
ness connector U-C34 (WP 0009,
Figure 217) terminal 2, and termi-
nal 4.
0031-82