TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2113-04 Operator In-Seat
Test Step 2. Test for Shorted Rear
Switch Voltage Below Nor-
Chassis Wiring Harness to Trans/
mal - Continued
Chassis ECM.
1. Disconnect the rear chassis wir-
ing harness connector FA-C20
(WP 0009, Figure 113) from trans-
mission ECM J-1 (WP 0009, Fig-
ure 112).
2. Using digital multimeter, measure
Continuity - Proceed to Test Step 3.
resistance between rear chassis
No Continuity - Proceed to Test Step
wiring harness connector FA-C20
4.
(WP 0009, Figure 113) terminal
63 and terminal 70.
There should be no continuity.
Test Step 3. Test for Shorted Cab
Lower Wiring Harness.
1. Disconnect the rear chassis wir-
ing harness connector FA-C22
(WP 0009, Figure 47) from cab
lower wiring harness connector P-
C69 (WP 0009, Figure 46).
2. Using digital multimeter, measure
Continuity - Cab lower wiring
resistance between cab lower wir-
harness is shorted, replace cab lower
ing harness connector P-C69
wiring harness (WP 0266).
(WP 0009, Figure 46) terminal 67
Connect the rear chassis wiring
and terminal 43.
harness connector FA-C20 (WP 0009,
There should be no continuity.
Figure 113) to transmission ECM J-1
(WP 0009, Figure 112).
Proceed to step 3.
No Continuity - Rear chassis wiring
harness is shorted, replace rear
chassis wiring harness (WP 0188).
Connect the cab lower wiring harness
connector P-C2 (WP 0009, Figure
184) to operator in-seat switch (WP
0009, Figure 185) (WP 0284).
Proceed to step 3.
3. Using the MSD (WP 0006), select
2113-04 Code Active - Repeat
Trans/chassis 120M and verify
troubleshooting code from the
2113-04 is not active.
beginning.
2113-04 Code Not Active -
Troubleshooting complete.
0027-136