TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1473-03 Steering Control
2. Turn ignition switch and battery
Position Sensor #3 Voltage
disconnect switch to the OFF
Above Normal - Continued
position.
3. Disconnect the cab lower wiring
harness connector P-C48 (WP
0009, Figure 116) from LH joy-
stick connector J-3 (WP 0009,
Figure 117) (WP 0282).
4. Turn ignition switch and battery
disconnect switch to the ON posi-
tion.
Voltage OK (7.2 to 8.8 Volts) - 8 Volt
voltage between P-C48 (WP
power supply from transmission ECM
0009, Figure 116) terminal 2 and
and cab lower wiring harness OK,
terminal 3 (ground).
proceed to step 6.
Voltage should be 7.2 to 8.8 volts.
Voltage NOT OK - Proceed to Test
Step 2.
Voltage OK (11.8 to 12.3 Volts) -
voltage between P-C48 terminal 1
Sensor signal circuit, transmission
(WP 0009, Figure 116) and termi-
and implement ECM OK. Replace LH
nal 3 (ground).
joystick (WP 0282).
Voltage should be 11.8 to 12.3 volts.
Proceed to step 7.
Voltage Not OK - Sensor signal
circuit shorted or transmission or
implement ECM bad, proceed to Test
Step 4.
7. Using the MSD (WP 0006), select 1473-03 Code Active - Repeat
Implement 120M and verify 1473- troubleshooting code from the
03 is not active.
beginning.
1473-03 Code Not Active -
Troubleshooting complete.
Test Step 2. Test for Open Rear
Chassis Wiring Harness to 8 Volt
Power Supply.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect the cab lower wiring
harness connector P-C51 (WP
0009, Figure 118) from LH joy-
stick connector J-1 (WP 0009,
Figure 117) (WP 0282).
0027-101