TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1473-03 Steering Control
Test Step 7. Test for Open Cab
Position Sensor #3 Voltage
Lower Wiring Harness.
Above Normal - Continued
1. Disconnect the rear chassis
wiring harness connector FA-C22
(WP 0009, Figure 47) (WP 0188)
from cab lower wiring harness
connector P-C69 (WP 0009,
Figure 46).
2. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
resistance between cab lower wir-
Rear chassis wiring harness is open,
ing harness connector P-C69
replace rear chassis wiring harness
(WP 0009, Figure 46) terminal 51
(WP 0188).
and terminal 28.
Remove jumper wire from P-C48 (WP
Resistance should be less than
0009, Figure 116) terminal 1 and P-
5.0 ohms.
C51 (WP 0009, Figure 118) terminal
3.
Connect the cab lower wiring harness
connector P-C51 (WP 0009, Figure
118) to LH joystick connector J-1 (WP
0009, Figure 119) (WP 0282).
Connect the cab lower wiring harness
connector P-C48 (WP 0009, Figure
116) to LH joystick connector J-3 (WP
0009, Figure 117) (WP 0282).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Proceed to step 3.
Resistance 5.0 Ohms or Greater -
Cab lower wiring harness is open,
replace cab lower wiring harness (WP
0266).
Connect the rear chassis wiring
harness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Connect the rear chassis wiring
harness connector FA-C20 (WP 0009,
Figure 113) (WP 0137) to
transmission ECM J1 (WP 0009,
Figure 112).
Proceed to step 3.
0027-106
