TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1473-03 Steering Control
3. Using the MSD (WP 0006), select 1473-03 Code Active - Repeat
Position Sensor #3 Voltage
Implement 120M and verify 1473- troubleshooting code from the
Above Normal - Continued
03 is not active.
beginning.
1473-03 Code Not Active -
Troubleshooting complete.
Test Step 6. Test for Open Rear
Chassis Wiring Harness.
1. Disconnect the cab lower wiring
harness connector P-C51 (WP
0009, Figure 118) from LH joy-
stick connector J-1 (WP 0009,
Figure 117) (WP 0282).
2. Connect jumper wire between P-
C48 (WP 0009, Figure 116) termi-
nal 1 and P-C51 (WP 0009, Fig-
ure 118) terminal 3.
3. Disconnect the rear chassis wir-
ing harness connector FA-C20
(WP 0009, Figure 113) from trans-
mission ECM J1 (WP 0009, Fig-
ure 112).
Resistance Less Than 5.0 Ohms -
Replace transmission ECM (WP
wiring harness connector FA-C21
0137).
(WP 0009, Figure 124) terminal
Connect the cab lower wiring harness
34 and FA-C20 (WP 0009, Figure
connector P-C48 (WP 0009, Figure
113) terminal 21.
116) to LH joystick connector J-3 (WP
Resistance should be less than
0009, Figure 117) (WP 0282).
5.0 ohms.
Connect the cab lower wiring harness
connector P-C51 (WP 0009, Figure
118) to LH joystick connector J-1 (WP
0009, Figure 117) (WP 0282).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Proceed to step 5.
Proceed to Test Step 7.
5. Using the MSD (WP 0006), select 1473-03 Code Active - Repeat
Implement 120M and verify 1473- troubleshooting code from the
03 is not active.
beginning.
1473-03 Code Not Active -
Troubleshooting complete.
0027-105