TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1473-02 Steering Control
6. Using the MSD (WP 0006), select
1473-02 Code Active - Repeat
Position Sensor #3 Data
Implement 120M and verify 1473-
troubleshooting code from the
Erratic, Intermittent or Incor-
02 is not active.
beginning.
rect - Continued
1473-02 Code Not Active -
Troubleshooting complete.
Test Step 4. Test for Cab Lower Wir-
ing Harness to 8 Volt Power Supply.
1. Disconnect the rear chassis wir-
ing harness connector FA-C22
(WP 0009, Figure 47) (WP 0188)
from cab lower wiring harness
connector P-C69 (WP 0009, Fig-
ure 46).
2. Disconnect the rear chassis wir-
ing harness connector FA-C23
(WP 0009, Figure 17) (WP 0188)
from cab lower wiring harness
connector P-C71 (WP 0009, Fig-
ure 18).
3. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
resistance between P-C71 (WP
Rear chassis wiring harness is open,
0009, Figure 18) terminal 6 and
replace rear chassis wiring harness
P-C69 (WP 0009, Figure 46) ter-
(WP 0188).
minal 28 (WP 0009, Figure 18).
Remove jumper wire from P-C48
Resistance should be less than
terminal 2 (WP 0009, Figure 116) and
5.0 ohms.
P-C51 terminal 3 (WP 0009, Figure
118).
Connect the cab lower wiring harness
connector P-C48 (WP 0009, Figure
116) to LH joystick connector J-3 (WP
0009, Figure 117) (WP 0282).
Connect the cab lower wiring harness
connector P-C51 (WP 0009, Figure
118) to LH joystick connector J-1 (WP
0009, Figure 119) (WP 0282).
Proceed to step 4.
Resistance 5.0 Ohms or Greater -
Cab lower wiring harness is open,
replace cab lower wiring harness (WP
0266).
Connect the rear chassis wiring
harness connector FA-C20 (WP 0009,
Figure 113) (WP 0137) to
transmission ECM J1 (WP 0009,
Figure 112).
Proceed to step 4.
0027-97
