TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1473-02 Steering Control
6. Using the MSD (WP 0006), select
1473-02 Code Active - Repeat
Position Sensor #3 Data
Implement 120M and verify 1473-
troubleshooting code from the
Erratic, Intermittent or Incor-
02 is not active.
beginning.
rect - Continued
1473-02 Code Not Active -
Troubleshooting complete.
Test Step 3. Test for Open Rear
Chassis Wiring Harness to 8 Volt
Power Supply.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect the cab lower wiring
harness connector P-C51 (WP
0009, Figure 118) from LH joy-
stick connector J-1 (WP 0009,
Figure 117) (WP 0282).
3. Connect jumper wire between P-
C48 terminal 2 (WP 0009, Figure
116) and P-C51 terminal 3 (WP
0009, Figure 118).
4. Disconnect the rear chassis wir-
ing harness connector FA-C20
(WP 0009, Figure 113) from trans-
mission ECM J1 (WP 0009, Fig-
ure 112).
5. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
resistance between FA-C20 (WP
Replace transmission ECM (WP
0009, Figure 113) terminal 44 and
0137).
terminal 21 (WP 0009, Figure 18).
Remove jumper wire between P-C48
Resistance should be less than
terminal 2 (WP 0009, Figure 116) and
5.0 ohms.
P-C51 terminal 3 (WP 0009, Figure
118).
Connect the cab lower wiring harness
connector P-C51 (WP 0009, Figure
118) to LH joystick connector J-1 (WP
0009, Figure 119) (WP 0282).
Connect the cab lower wiring harness
connector P-C48 (WP 0009, Figure
116) to LH joystick connector J-3 (WP
0009, Figure 117) (WP 0282).
Proceed to step 6.
Resistance 5.0 Ohms or Greater -
Proceed to Test Step 4.
0027-96
