TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1473-03 Steering Control
3. Connect jumper wire between P-
Position Sensor #3 Voltage
C48 terminal 2 (WP 0009, Figure
Above Normal - Continued
116) and P-C51 terminal 3 (WP
0009, Figure 118).
4. Disconnect the rear chassis wir-
ing harness connector FA-C20
(WP 0009, Figure 113) from trans-
mission ECM J1 (WP 0009, Fig-
ure 112).
5. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
resistance between FA-C20 (WP
Replace transmission ECM (WP
0009, Figure 113) terminal 44 and
0137).
terminal 21 (WP 0009, Figure 18).
Remove jumper wire from P-C48
Resistance should be 5.0 ohms or
terminal 2 (WP 0009, Figure 116) and
less.
P-C51 terminal 3 (WP 0009, Figure
118).
Connect the cab lower wiring harness
connector P-C51 (WP 0009, Figure
118) to LH joystick connector J-1 (WP
0009, Figure 119) (WP 0282).
Connect the cab lower wiring harness
connector P-C48 (WP 0009, Figure
116) to LH joystick connector J-3 (WP
0009, Figure 117) (WP 0282).
Proceed to step 6.
Resistance 5.0 Ohms or Greater -
Proceed to Test Step 3.
6. Using the MSD (WP 0006), select 1473-03 Code Active - Repeat
Implement 120M and verify 1473- troubleshooting code from the
03 is not active.
beginning.
1473-03 Code Not Active -
Troubleshooting complete.
Test Step 3. Test for Cab Lower Wir-
ing Harness to 8 Volt Power Supply.
1. Disconnect the rear chassis wir-
ing harness connector FA-C22
(WP 0009, Figure 47) (WP 0188)
from cab lower wiring harness
connector P-C69 (WP 0009, Fig-
ure 46).
0027-102
